Brother MFC 7840W - Manual (Page 124)

110
No Response/Busy The number you dialed does not
answer or is busy. Verify the number and try again.
Not Registered You tried to access a One Touch
or Speed Dial number that is not
programmed. Set up the One Touch or Speed Dial
number.
(See Storing one touch dial numbers
on page 54 and Storing speed dial numbers
on page 55.)
Out of Memory The machine’s memory is full. Fax sending or copy operation in
progress
Do one of the following:
„ Press Start to send or copy the scanned
pages.
„ Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
„ Clear the data from the memory. (See
Out of memory message on page 38 or
page 75.)
Print operation in process
Do one of the following:
„ Reduce print resolution. (See Advanced
tab in the Software User’s Guide on the
CD-ROM.)
„ Clear the faxes from the memory. (See
Out of memory message on page 75.)
Print Unable XX The machine has a mechanical
problem. Do one of the following:
„ (MFC-7340, MFC-7345N and MFC-
7440N only)
See Transferring your faxes or Fax
Journal report on page 111 before
disconnecting the machine so you will
not lose any important messages.
Then, disconnect the machine from the
power for several minutes and then
reconnect it.
„ (MFC-7840W only)
Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for
approximately 4 days without losing
faxes stored in the memory. See
Transferring your faxes or Fax Journal
report on page 111.)
Error Message Cause Action