Brother PocketJet PJ-673 w WLAN - Manual (Page 19)

Setting Up the Printer
15
1
f
When the WIRELESS LAN indicator
stops blinking and remains lit, the printer
is connected. Print from the printing
software created with the SDK.
NOTE
It may take more than 1 minute to
establish a wireless LAN connection.
Since it differs depending on the device
and environment, check with the device
manufacturer.
 If printing is not possible
In the following cases, the wireless LAN
connection between the printer and iOS
device will be cut, preventing printing.
1 The iOS device has entered sleep
mode.
2 The printer has been turned off.
3 The printer has been switched to USB
mode.
For the cases mentioned above, perform
the operations below to re-establish the
connection.
1 Select the SSID for the ad-hoc mode
for step e on page 14.
2 Select the connection for step a on
page 14.
3 Hold down the (Power) button for at
least 3 seconds to enter wireless LAN
mode, and then select the SSID for the
ad-hoc mode for step c on page 14.
Connecting the Printer
and a Windows
®
Computer
1
Printing From a Windows
®
Computer Via a Wireless LAN
Connection
1
NOTE
• This printer can establish a connection
with the “Open System” authentication
method and when the encryption method
is set to “None” or the “WEP” ad-hoc
mode.
• The printer settings will be specified when
the printer driver is installed on the
Windows
®
computer. Prepare the
computer and the USB cable.
• Log on with administrator rights.
• If, while specifying the settings, a dialog
box appears requesting administrator
rights or requesting confirmation to
perform the operation with administrator
rights, follow the instructions.
• If, while specifying the settings, a dialog
box appears requesting confirmation to
continue the installation, continue it.
• The descriptions in this manual apply to
wireless LAN connections that can be set
up using procedures for a standard
operating system. For any other cases,
refer to the instruction manual included
with your wireless LAN adapter or
Windows
®
Computer.
• If a firewall is being used, the installation
may not be completed correctly. Open
TCP/IP port number 9100. If you are
unsure of how to perform the operation,
check with the administrator who originally
specified the settings.