Brother PocketJet PJ-673 w WLAN - Manual (Page 8)

Chapter 1
4
Removing the Rechargeable Ni-MH
Battery
1
a
Open the battery cover by pressing the
cover latch.
b
Swing the cover open and remove it.
c
Gently pull the battery removal ribbon
until the rechargeable Ni-MH battery
starts to tilt out of its compartment.
1 Battery removal ribbon
NOTE
If the battery removal ribbon is trapped
behind the rechargeable Ni-MH battery,
insert a thin metal object such as a
flat-blade screwdriver between the battery
and the case at the end away from the
AC/DC connector and tilt it out of its
compartment.
d
Remove the rechargeable Ni-MH
battery from the compartment.
e
Gently pull the rechargeable Ni-MH
battery connector and disconnect it from
the terminal inside the printer.
Charging the Rechargeable
Ni-MH Battery
1
Perform the following procedure to charge
the rechargeable Ni-MH battery.
NOTE
• Charge the rechargeable Ni-MH battery
immediately after purchase using the
following procedure.
• Up to 120 minutes is needed to fully
charge a rechargeable Ni-MH battery.
About 70 pages can be printed when
using a new, fully-charged rechargeable
Ni-MH battery.
a
Install the rechargeable Ni-MH battery
into the printer.
b
Use the AC adapter and AC power cord
to connect the printer to an AC power
outlet, or use the DC cable to connect
the printer to a DC power outlet.
c
Make sure that the printer is turned off.
d
Press and hold the (Power) button for
a few seconds until the POWER
indicator begins to blink in green.
NOTE
• Depending on the settings specified in PJ-
673 Utility, charging of the rechargeable
Ni-MH battery may begin after the battery
is refreshed. For more information, see
Refresh Ni-MH Battery on page 46.
• While the POWER indicator is blinking in
green and orange, the power remaining in
the rechargeable battery is being
discharged and the battery is being
refreshed (see Explaining Battery Terms
on page 5).
• If there is still a considerable amount of
charge in the rechargeable Ni-MH battery,
it may not be refreshed.
• While the rechargeable Ni-MH battery is
being refreshed, press and hold the
(Power) button to stop refreshing the
battery and begin charging it.
1