Brother HE1 - Manual (Page 36)

34
GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
b
Cut the thread with scissors beside the bobbin-
winding thread guide.
a Bobbin-winding thread guide
c
Slide the bobbin winder shaft to the left, and
then remove the bobbin from the shaft.
d
Hold the thread end with your left hand, and
wind off the thread clockwise near the bobbin
with your right hand as shown below.
e
Wind the bobbin again.
Note
z Make sure that the thread passes under the
pretension disk of the bobbin-winding
thread guide correctly (page 31).
Installing the bobbin
Install the bobbin wound with thread.
CAUTION
Memo
z The order that the bobbin thread should be
passed through the bobbin case is indicated
by marks that surround the bobbin case.
a
● Use a bobbin that has been correctly
wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.
● The included bobbin was designed
specifically for this machine. If bobbins
from other models are used, the machine
will not operate correctly. Use only the
included bobbin or bobbins of the same
type (part code: SA156, SFB (XA5539-
151)).
This model Other model
11.5 mm
(7/16 inch)
Actual size
0711-0120-C-combo_E.book Page 34 Thursday, July 24, 2008 1:46 PM