Brother MFC-820CW - Manual (Page 19)

Configuring your machine for a network with an Ethernet cable connection
2 - 4
2
Note
• If the print server is set to its factory default settings without using a DHCP/BOOTP/RARP server, the
device will appear as an APIPA device in the BRAdmin Professional utility screen.
• You can find the node name and Ethernet address (Node Address above) by printing out the Network
Configuration List. See
Printing the Network Configuration List on page 4-20 for information on how to
print the Network Configuration List on your print server.
4
Double click the unconfigured device.
5
Enter the IP address, Subnet Mask and Gateway (if needed) of your print server.
6
Click OK.
7
With the correctly programmed IP address, you will see the Brother print server in the device list.
Using the control panel to configure your machine for a network
You can configure your machine for a network using the control panel LAN menu. See Control panel setup
on page 4-1.
Using other methods to configure your machine for a network
You can configure your machine for a network using other methods. See Other ways to set the IP address
(for advanced users and administrators) on page A-1.