Brother PE-770 - Manual (Page 26)

GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
24
Winding/Installing the Bobbin
This section describes how to wind the thread onto the bobbin, and then insert the bobbin thread.
Bobbin precautions
Be sure to observe the following precautions
concerning the bobbin.
CAUTION
Winding the bobbin
Wind the thread around the bobbin to prepare the
bobbin thread.
a
Turn on the machine.
b
Open the top cover.
c
Place the bobbin on the bobbin winder shaft so
that the spring on the shaft fits into the notch
in the bobbin
.
Press down on the bobbin until it snaps into
place.
a Notch
b Bobbin winder shaft spring
d
Slide the bobbin winder in the direction of the
arrow until it snaps into place.
• (Start/stop button) lights up in orange.
e
Remove the spool cap that is inserted onto the
spool pin.
a Spool pin
b Spool cap
● Only use the Bobbin (part code: SA156,
SFB: XA5539-151) designed specifically
for this machine. Use of any other bobbin
may result in injuries or damage to the
machine.
● The included bobbin was designed
specifically for this machine. If bobbins
from other models are used, the machine
will not operate correctly. Use only the
included bobbin or bobbins of the same
type (part code: SA156, SFB: XA5539-
151).
11.5 mm
Actual size
This model Other model
(7/16 inch)
2
1
1
2