Brother PE-770 - Manual (Page 53)

Selecting Embroidery Patterns 51
2
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
■ LCD button
• For details, refer to “Resewing” (page 65).
• For details, refer to “Adjusting the layout”
(page 61).
Memo
z Keys that appear surrounded with a dotted
line cannot be used.
When a specific pattern is selected,
press this key and then, press
to switch the display. The
embroidery settings such as the
specified character string and color
are confirmed.
Press this key to change the thread
settings.
Press this key to select or cancel
programmed thread cutting.
Press or to adjust the thread
tension.
Press or to change the
thread density (alphabet and frame
patterns only).
Press this key to adjust the pattern.
Press this key when you want to
change the color character by
character in character embroidery.
Since the machine stops at the end of
each character, the upper thread is
changed as you embroider.
Press this key again to cancel multi-
color.
The needle progresses one color or
one stitch (if pressed continuously, 9
stitches to 20 stitches) at a time and
changes the position for starting the
embroidery. This is used when a
specific color is not embroidered or
when restarting the machine after
power has been turned off in the
middle of the operation.
Back one
color
Forward
one color
Back one
stitch
Forward
one stitch
The position of the pattern within the
embroidery frame can be checked,
and the size and angle can be
changed.