Brother PE-770 - Manual (Page 32)

GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
30
Upper Threading
This section describes how to position the spool for the upper thread, and then thread the needle.
CAUTION
About the spool of thread
Information about the spools of thread is described
below.
CAUTION
Threading the upper thread
Set the spool of thread on the spool pin, and then
thread the machine.
a
Turn on the machine.
b
Raise the presser foot lever to raise the presser
foot.
a Presser foot lever
Note
z If the presser foot is not raised, the machine
cannot be threaded.
c
Press (Needle position button) once or
twice to raise the needle.
a Needle position button
X
The needle is correctly raised when the mark on
the handwheel is at the top, as shown below.
Check the handwheel and, if this mark is not at
this position, press
(Needle position button)
until it is.
a Mark on handwheel
● When threading the upper thread, carefully follow the instructions. If the upper threading is
not correct, the thread may become tangled or the needle may bend or break.
● Three spool cap sizes are available,
allowing you to choose a spool cap that
best fits the size of spool being used. If the
spool cap is too small for the spool being
used, the thread may catch on the slit in
the spool or the needle may break.
a
1
1