Brother Innov-is 85e - Manual (Page 24)

GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
22
Winding/Installing the Bobbin
This section describes how to wind the thread onto the bobbin, and then insert the bobbin thread.
Bobbin precautions
Be sure to observe the following precautions concerning the bobbin.
CAUTION
Winding the bobbin
Wind the thread around the bobbin to prepare the bobbin thread.
a Hook of the bobbin-winding thread guide
b Pretension disk
c Bobbin winder shaft
d Bobbin
Memo
z The order that the machine should be threaded for winding the bobbin is indicated by a broken line on
the sewing machine. Be sure to thread the machine as indicated.
● Only use the bobbin (part code: SA156, SFB(XA5539-151)) designed specifically for this
sewing machine. Use of any other bobbin may result in injuries or damage to the machine.
● The included bobbin was designed specifically for this sewing machine. If bobbins from other
models are used, the machine will not operate correctly. Use only the included bobbin or
bobbins of the same type (part code: SA156, SFB(XA5539-151)).
1
2 3
4
a Actual size
b This model
c Other model
d 11.5 mm (7/16 inch)
a