Brother HL-3140CW - Manual (Page 57)

Web Based Management
51
5
• Auto: If you choose Auto, the machine will initially search for a Kerberos server. If the Kerberos
server is not detected, NTLMv2 will be used for the authentication method.
• Kerberos: Choose Kerberos to use Kerberos Authentication only.
• NTLMv2: Choose NTLMv2 to use NTLMv2 Authentication only.
For Kerberos and NTLMv2 Authentication, you must also configure the SNTP protocol
(network time server).
For configuring the SNTP settings, see How to configure the SNTP protocol using Web Based
Management on page 49.
 Username
Enter the Username for the authentication up to 96 characters.
NOTE
If the username is part of a domain, please input the username in one of the following styles: user@domain
or domain\user.
 Password
Enter the password for the authentication up to 32 characters.
 Kerberos Server Address (if needed)
Enter the KDC Host Address (for example: mypc.example.com) (up to 64 characters) or the IP
address (for example: 192.168.56.189).
 Error Detection Setting (See Error Detection Setting on page 52.)
d
In the Connection Status, you can confirm the last log status. For more information, see Understanding
Error Messages on page 53.
e
Click Submit to display the Test Print Log to Network page.
To test your settings, click Yes and go to step f.
To skip the test, click No. Your settings will be submitted automatically.
f The machine will test your settings.
g
If your settings are accepted, Test OK appears on the page.
If Test Error appears, check all settings, and then click Submit to display the Test page again.