Brother HL-1870N - Manual (Page 141)

APPENDIX
A-2
TELNET
To connect to the print server using TELNET on UNIX, Windows NT, or most
other TCP/IP systems, type: TELNET ipaddress at the command prompt of
the system prompt, where ipaddress is the IP address of the print server. When
you are connected, push RETURN or ENTER to get the "#" prompt, enter the
password "access" (the password will not appear on the screen), and type
anything in response to the Enter Username> prompt. When you see the
Local>
prompt, you are ready to enter commands.
Enter HELP at the command prompt for a list of supported commands. For a
complete list of supported commands along with an explanation of them, please
refer to the file commands.pdf
BRCONFIG
Brother BRCONFIG utility runs on the DOS system prompt and is installed with
BRAdmin. To connect the print server using the Brother BRCONFIG NetWare
utility, Choose the BRCONFIG utility from the Brother BRAdmin utilities menu.
If you have only one print server, you will be immediately connected to that
server. If you have more than one print server, you will be given a list of
available print servers. Type the number of the print server to which you wish to
connect. When you are connected, enter the password "access" (the password
will not appear on the screen) at the "#" prompt, and type anything in response to
the Enter Username> prompt. When you get the Local> prompt, you are
ready to enter commands. To use BRCONFIG, a Novell Server (running the IPX
protocol) is necessary and an active connection must be made to the server.
Enter HELP at the command prompt for a list of supported commands.