Brother HL-1870N - Manual (Page 59)

CHAPTER 5 BIP INTERNET PRINTING INSTALLATION
5-6
Brother Internet Print
Using TELNET to Configure the Print
Server
Skip this section if you used BRAdmin or a Web Browser to configure the
remote print server.
As an alternative to BRAdmin, you can use the print server remote console to
configure the print server. The console can be accessed via TELNET. When you
access the print server using these utilities, you will be asked for a password. The
default password is "access".
1. When you get the "Local>" prompt after connecting to the console, enter
the command:
SET POP3 ADDRESS ipaddress
where ipaddress is the IP address of your POP3 server (consult with your
network administrator if you do not know this address).
2. Enter the command:
SET POP3 NAME mailboxname
SET POP3 PASSWORD emailpassword
where mailboxname is the name of the remote print server mailbox and
emailpassword is the password associated with this mailbox. Usually the
mailbox name is the same as the first part of the E-mail address that you
defined previously (for example, usually if the E-mail address is
[email protected], then the mailbox name is emailprinter).
3. The print server is set by default to poll the POP3 server every 30
seconds. If you wish to change this value, enter the command:
SET POP3 POLLING rate
where rate is the polling rate in seconds.
Type EXIT to exit the console and save the changes. You have now
completed configuring the print server.