Brother HL-S7000DN - Manual (Page 5)

5
e
Close the ink cartridge cover. 5
Check the print quality
a
When the preparation process has finished, the
machine will print a test page.
Check the print quality of the test page.
b
If the printout looks clear and visible, press 1
(Yes) to finish the quality check and go to
step
6.
If the printout has a quality problem, press 2
(No). The machine will start cleaning and print
a test page again.
6
Set your language
a
Press Menu.
b
Press a or b to choose General Setup.
Press OK.
c
Press OK to choose Local Language.
d
Press a or b to choose your language.
Press OK.
Note
The machine will prepare the ink tube system for
printing. This process will take approximately
15 minutes. Do not turn off the machine.
Important
• DO NOT take out the ink cartridge if you do not
need to replace it.
• DO NOT repeatedly insert and remove the
cartridge. If you do, ink may seep out of the
cartridge.
• Once you open an ink cartridge, install it in the
machine and use it up within six months of
installation. Use an unopened ink cartridge by
the expiration date written on the cartridge
package.
• DO NOT dismantle or tamper with the ink
cartridge, as this can cause the ink to leak out
of the cartridge.
• Brother strongly recommends that you DO
NOT refill the ink cartridge provided with your
machine. We also strongly recommend that
you continue to use only Genuine Brother
Brand replacement ink cartridges. Use or
attempted use of third party ink and/or
cartridges in the Brother machine may cause
damage to the machine and/or may result in
unsatisfactory print quality. In addition, use of
third party ink and/or cartridges may trigger
incorrect status messages, cause the printer to
stop prematurely or otherwise malfunction. Our
limited warranty coverage does not apply to
any problem that is caused by the use of third
party ink and/or cartridges. To protect your
investment and obtain premium performance
from the Brother machine, we strongly
recommend the use of Genuine Brother
Supplies.
Note
If an error message is displayed, follow the
instructions shown on the LCD.