Brother XR1300 - Manual (Page 60)

58
UTILITY STITCHES —————————————————————————————————————————————————————————————————————————————————————————————————————
e
Attach the presser foot holder to the right side
of the pin on zipper foot “I”.
a Pin on the right side
b Needle drop point
f
Select stitch .
g
With the right side of the fabric facing up,
continue sewing with the zipper on the right
side of the presser foot.
a Stitching
b Right side of fabric
c Basting stitching
d End of zipper opening
Sew the stitching in order, from
a
to
c
.
Memo
● If the presser foot contacts the zipper slider,
leave the needle lowered (in the fabric) and
raise the presser foot. After moving the
slider so it will not contact the presser foot,
lower the presser foot and continue sewing.
● To sew with the zipper on the left side of the
presser foot, attach the presser foot holder
to the left side of the pin on zipper foot “I”
in step
e
.
a Left side of the pin
b Needle drop point
h
When you have finished sewing, remove the
basting stitching.
● Turn the handwheel by hand to make sure the
needle does not hit the presser foot before
you start sewing. If you choose a different
stitch, the needle will hit the presser foot and
break the needle. You may also be injured.
● Make sure the needle does not hit the zipper
during sewing. If the needle hits the zipper,
the needle may break and you may be injured.
I
CAUTION
CAUTION
I