Brother HL 3070CW - Manual (Page 24)

24
Windows
® Wireless Network
h
If the confirmation screen appears, check the
box and click Next. When the following screen
appears, check Yes if you want to connect with
the listed SSID. Click Next and go to
l.
i
The wizard will search for wireless networks
available from your machine. Choose the SSID
that you wrote down for your network in step 9
on page 21, and then click Next.
j
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to
l.
k
Enter the Network Key you wrote down in
step 9 on page 21 and then enter the key again
in Confirm Network Key, then click Next.
l
Click Next. The settings will be sent to your
machine.
m
Disconnect the USB cable between the
computer and the machine.
Wireless setup is completed.
n
Click Next to continue to install the printer
driver.
Note
• If the list is blank, check that the access point
has power and is broadcasting the SSID, and
then see if the machine and the access point
are within range for wireless communication.
Then, click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Advanced button. Follow the on-screen
instructions for entering the Name (SSID), and
then click Next.
Note
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry.