Brother HL-S7000DN - Manual (Page 90)

General Information
84
3
Network Menu
Submenu 1 Submenu 2 Menu Selections Options Descriptions
Wired LAN TCP/IP Boot Method Auto* / Static / RARP /
BOOTP / DHCP Chooses the IP method that
best suits your needs.
IP Address ###.###.###.###
(000.000.000.000)*
1
Enter the IP address.
Subnet Mask ###.###.###.###
(000.000.000.000)*
1
Enter the Subnet mask.
Gateway ###.###.###.###
(000.000.000.000)*
1
Enter the Gateway address.
Node Name BRNXXXXXXXXXXXX Enter the Node name.
WINS Config Auto* / Static Chooses the WINS
configuration mode.
WINS Server (Primary)
000.000.000.000
(Secondary)
000.000.000.000 Specifies the IP address of the
primary or secondary WINS
server.
DNS Server (Primary)
000.000.000.000
(Secondary)
000.000.000.000 Specifies the IP address of the
primary or secondary DNS
server.
IP Boot Tries 0 / 1 / 2 / 3* / ... / 32767 Specifies the number of
attempts the machine will try to
obtain an IP address when the
Boot Method is set to any
setting except Static.
APIPA On* / Off Automatically allocates the IP
address from the link-local
address range.
1
IPv6 On / Off* Sets use of IPv6 protocol.
Ethernet - Auto* / 100B-FD / 100B-HD /
10B-FD / 10B-HD Chooses Ethernet link mode.
Wired Status - Active 1000B-FD /
Active 100B-FD /
Active 100B-HD /
Active 10B-FD /
Active 10B-HD /
Inactive / Wired OFF Shows the Ethernet link status.
MAC Address - - Shows MAC address of the
machine.
Set to Default Restores wired network settings of the internal print server to the factory default.
Wired Enable -
On* / Off Chooses Ethernet link mode.
The factory settings are shown in Bold with an asterisk.