Brother NC-2100p - Manual (Page 54)

CHAPTER 5 BIP INTERNET PRINTING INSTALLATION
5-8
10. Press OK to continue. You will then be asked to re-start your computer.
11. Once your computer has re-started you must create a printer on your
Windows 95/98/Me/NT4.0/2000/XP system using the standard Windows
95/98/Me/NT4.0/2000/XP printer setup procedure. To do this, go the Start
button, select Settings and then Printers (Windows 95/98/Me/NT4.0/2000).
To do this, go the Control Panel, select Printers and Other Hardware and
then Printers and Faxes (or Add a printer) (Windows XP).
12. Select Add Printer to begin the printer installation.
13. Click Next when you get the Add Printer Wizard window (Windows
95/98/Me only).
14. Select Local Printer (Windows 95/98/Me/2000), My computer (Windows
NT4.0) or Local printer attached to this computer (Windows XP) when you
are asked how the printers are connected to your computer and push Next.
<For Windows 95/98/Me users>
15. Select the desired model of the remote printer (for example, Brother HL-
series). If necessary, click Have Disk to load the driver from the printer's
installation diskette. Click Next when you are done.
16. If you have selected a printer driver that is already being used, you have the
option of either keeping the existing driver (recommended) or replacing it.
Select the desired option and press Next.
17. Select the Brother Internet port (BIP...) and press Next.
<For Windows NT4.0/2000/XP users>
15. Select the Brother Internet port (BIP...) and press Next.
16. Select the desired model of the remote printer (for example, Brother HL-
series). If necessary, click Have Disk to load the driver from the printer's
installation diskette. Click Next when you are done.
17. If you have selected a printer driver that is already being used, you have the
option of either keeping the existing driver (recommended) or replacing it.
Select the desired option and press Next.
18. Enter any desired name for the BIP remote printer and press Next. Note that
this name does not need to match the Port name that you assigned in step 6,
or E-mail address that you assigned in step 9.
19. Select No when asked if you want to print a test page, unless you have
already configured the remote print server to receive BIP print jobs.
You have now finished installing the BIP software. If you need to configure another
remote print server , go to next section, Adding a Second Brother Internet Port.