Pulling up the bobbin thread – Brother CS-8150 User Manual

Page 41

Advertising
background image

Upper Threading 35

1

Pulling up the bobbin thread

When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.

1

Insert the bobbin into the shuttle.
• Refer to steps

1

through

5

of “Installing the

bobbin” (page 22).

2

Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.

3

While lightly holding the upper thread with
your left hand, press

(needle position

button) twice to raise the needle.

1 Needle position button

X

The bobbin thread is looped around the
upper thread and can be pulled up.

4

Carefully pull the upper thread upward to pull
out the end of the bobbin thread.

5

Pull out about 10-15 cm (3/8-5/8 inch) of the
bobbin thread under the presser foot toward
the rear of the machine.

6

Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.

1

2

1

S3_brotherE.book Page 35 Wednesday, February 12, 2003 11:49 AM

Advertising