Setting the night mode, Operating the external device output, Displaying event status – Canon VB-M700F User Manual

Page 108: Setting the night mode -14, Operating the external device output -14, Displaying event status -14, 14) is enabled

Advertising
background image

7

-14

Example of Setting Method:

Irradiate a white subject (white paper, etc.) using the

light source and capture the subject over the entire

screen. In this condition, select [One-shot WB].

Setting the Night Mode

Switch between [Day Mode] and [Night Mode].

Note

The Night Mode cannot be used if [Auto] is set for day/night
under [Camera] on the Setting page (P. 5-10).

[Day Mode]
Color image can be viewed in the normal mode.

[Night Mode]
Images are shown in black and white, due to the

disabling of the infrared cut filter.

Note

Refer to the notes on P. 3-7 for focus ranges when [Night Mode]
is enabled (P. 5-10, P. 7-14).

Operating the External Device Output

You can operate the external device output and display

the current output status using an icon. The [ON]/[OFF]

status can be switched by clicking this icon.

Example:

Output1: Output OFF

Output2: Output ON

Displaying Event Status

Clicking the [Event Display] button will show the event

display panel, which shows the input status of external

devices, as well as the status of image and volume

detection by the intelligent function.

1

[External Device Input]
When a contact input signal is received from an

external device, input will be turned ON and an icon

will be displayed.

Example:

Input1: Input OFF

Input2: Input ON

Important

• Since the light source selection options are based on

representative characteristics, proper colors may not be
achieved depending on the applicable light source. In this
case, use the [One-shot WB] function.

• If the subject looks greenish under mercury lamps in the

[Auto] mode, select the [Mercury Lamp] mode under light
source. If the image is still not shown in appropriate colors
under mercury lamps when the [Mercury Lamp] mode is
selected under light source, use the [Auto] mode.

• Notes on capturing video continuously day and night

If a subject that seldom changes is captured in a location
where the light source changes gradually, such as when
capturing a subject continuously day and night, the image
may not be shown in appropriate colors.

• When the subject has only one color or when sodium lamps,

mercury lamps and certain other fluorescent lightings are
used, camera colors may not be adjusted automatically.

• When [Night Mode] is set (including when it is set to [Auto]

and night mode is judged to be applicable), the white
balance function cannot be used.

Advertising
This manual is related to the following products: