Performing initial settings for the camera, Performing initial settings for the camera -5 – Canon VB-M700F User Manual

Page 29

Advertising
background image

2

-5

2

Ini
tial
S

ettings

Use the VB Initial Setting Tool to configure the camera

network.

To launch the VB Initial Setting Tool, double-click the

[VB Initial Setting Tool] icon on the desktop or select

[All Programs] > [WebView Livescope] > [VB Initial

Setting Tool] from the [Start] menu.

The Tool will automatically detect the camera

connected to the network and display the camera's

MAC address, IP address and model name.

The factory setting IP address is set to 192.168.100.1.

The MAC address can be found on the label on the

camera (“Part Names” in the “Installation Guide”).

The VB Initial Setting Tool cannot be used with

cameras that are behind a router.

To use a setting other than the default gateway

setting, clear the [Enter a default gateway address]

checkbox.

After settings are complete, click [OK].

Setup progress is shown in the window.

Note

• To ensure security, be sure to change the administrator

password (P. 4-3).

• Contact your System Administrator for the appropriate IP

address, subnet mask and gateway address.

Performing Initial Settings for the Camera

1

Connect the camera and PC to the network and turn
on the camera (“Connecting the Camera” in the

“Installation Guide”).

2

Launch the VB Initial Setting Tool.

Important

• The camera will stop issuing IP address assignment requests

20 minutes after it is turned on, and the VB Initial Setting Tool
detection will be disabled. In such cases, turn the camera off
and on again.

• There may be cautionary information, depending on your

operating environment. Read “Notes on Operating
Environment” (P. 1-9) before performing
initial settings.

3

Select a MAC address, and then click [Initial setting].

4

Enter the user name “root” and factory default setting
password “camera”, and then the appropriate IP

address and subnet mask.

5

Click [OK].

Important

To obtain an IP address from a DHCP server, first use the VB
Initial Setting Tool to temporarily configure a static address that
can communicate with the PC. Then, in [Network] in the setting
page, change [IPv4 Address Setting Method] to [Auto (DHCP)]
in the [IPv4] area (P. 5-5).

Click to select

Advertising
This manual is related to the following products: