Canon VB-M40 User Manual

Page 57

Advertising
background image

[IPsec] IPsec Settings

4

-27

4

S

et

ting Page

A

g

[SA ESP SPI (inbound)]
Set the SA SPI value for inbound.

Set a desired value in the range of 256 to 4294967295.

Since this setting is used as an ID for identifying the

SA, be careful not to specify an inbound SPI whose

value is already used in the SPI for other ESP.

• If [Security Protocol] was set to [AH] or [ESP and AH] in

5

, A

h

[SA AH Authentication Algorithm] to S

q

[SA AH

SPI (inbound)] must be set.

A

h

[SA AH Authentication Algorithm]
Set the AH authentication algorithm to

[HMAC_SHA1_96] or [HMAC_MD5_96] according to

the authentication algorithm supported by the device to

connect to.

A

j

[SA AH Authentication Key (outbound)]
Set the SA authentication key for outbound.

If [HMAC_SHA1_96] or [HMAC_MD5_96] was selected

in A

h

, set a 160-bit or 128-bit hexadecimal,

respectively.

A

k

[SA AH SPI (outbound)]
Set the SA SPI value for outbound.

Set a desired value in the range of 256 to 4294967295.

A

l

[SA AH Authentication Key (inbound)]
Set the SA authentication key for inbound.

If [HMAC_SHA1_96] or [HMAC_MD5_96] was selected

in A

h

, set a 160-bit or 128-bit hexadecimal,

respectively.

S

q

[SA AH SPI (inbound)]

Set the SA SPI value for inbound.

Set a desired value in the range of 256 to 4294967295.

Since this setting is used as an ID for identifying the

SA, be careful not to specify an inbound SPI whose

value is already used in the SPI for other AH.

Note

If IPsec is used, video transmission performance drops.

Important

• To run this camera with IPsec, the communicating devices

and network must be set beforehand. Contact your System

Administrator for these settings.

• If any setting is changed from the [IPsec] menu, the camera

may become inaccessible from the active web browser.
Check beforehand the precautions in “Important” in "[Reboot

Item] Setting Items Requiring Rebooting" (P. 4-32).

Advertising