Canon EOS C300 - Manual (Page 119)

119
Clip Operations
2 Select the desired function and then press SET.
• The function is enabled. For some functions, further action may be required. Follow the onscreen directions.
• Press the CANCEL button instead to return to the clip index screen.
IMPORTANT
• Observe the following precautions while the CF2 or CF3 access indicator is illuminated in red. Failure to do
so may result in permanent data loss.
- Do not disconnect the power source or turn off the camcorder.
- Do not open the cover of the either CF card slot.
Displaying Clip Information
Select [Display Clip Info] in the clip menu to display the selected clip’s information screen ([Clip Info] screen).
Push the joystick left/right to switch to the previous/next clip. When you are finished, press the CANCEL button
to return to the clip index screen.
Displaying the Lens Information and User Memo
From the [Clip Info] screen, push the joystick up or turn the SELECT dial up to display the [Lens & Q] screen.
In this screen you can check details about the lens used to record the clip. If the clip has an embedded user
memo, you will see the user memo content in this screen as well. Push the joystick down or turn the SELECT
dial down to return to the [Clip Info] screen.
9
4 5 6
1
2
3
8
10
13
14
15
16
17
11
12
7
1 Thumbnail of the selected clip
2 Thumbnail of the previous clip
3 Thumbnail of the next clip
4 Shot mark (A 90, 124)
5 Special recording mode (A 93)
6 Currently selected CF card slot (A 43)
7 Clip number / Total number of clips
8 Recording date and time
9 Clip name (A 51)
10 Bit rate and resolution (A 55)
11 Frame rate (A 55)
For slow & fast motion recording mode, the
shooting and playback frame rates will be
displayed.
12 $ mark / % mark (A 91, 120)
13 Embedded custom picture file (A 91)
14 Time code of the clip thumbnail
15 Time code of the first frame in clip
16 Time code of the last frame in clip
17 Clip duration
COP
Y