Removing the roll from the printer – Canon imagePROGRAF iPF6450 User Manual
Page 14
7
Close the Roll Feed Unit Cover.
Important
•
Cut the edge of the roll using the Paper Cutting function if the edge is creased or soiled. (See "Specifying the
Cutting Method for Rolls.")
→User's Guide
Note
•
Adjusting the printhead alignment with the type of paper to be used in printing may enhance printing quality.
(See "Automatic Adjustment to Straighten Lines and Colors.")
Removing the Roll from the Printer
Removing the Roll from the Printer
Remove rolls from the printer as follows.
Important
•
Once a roll has been advanced, do not pull the paper out by force. This will prevent further feeding, and the printer will
be unable to keep track of the amount of roll paper left.
If you accidentally pull out paper, follow these steps to remove the roll, and open the paper feed slot.
Note
•
If you need to cut the roll, see "Specifying the Cutting Method for Rolls."
→User's Guide
•
The operations for a printer with a Spectrophotometer Unit (option) are the same as for a printer with no Spectrophotom-
eter Unit (option). If it is difficult to perform operations from the front of the printer, lower the Up-down Unit. (See
"Lowering the Up-down Unit of the Spectrophotometer Unit (option) Manually.")
1
On the Tab Selection screen of the Control Panel, press
◀ or
▶ to select the
(Paper tab) .
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Paper Menu is displayed.
3
Press ▲ or ▼ to select Eject Paper, and then press the OK button.
Removing the Roll from the Printer
iPF6450
Handling Paper
Handling rolls
14