Acer Altos G500 - Manual (Page 54)

3 Upgrading your system 44
Installing and removing storage
devices
Your system supports one 3.5-inch and five 5.25-inch internal storage
devices. The empty drive bays allow you to install additional drives
such as a CD-ROM drive, a digital audio tape (DAT) drive or another
hard disk drive. These would provide your system additional storage
capacity.
Note: Your basic system already comes pre-installed with a CD-
ROM drive and a 3.5-inch floppy drive.
Replacing the 3.5-inch floppy drive
1 Remove the housing panels. Refer to page 36 for more detailed
instructions.
2 Disconnect the power and signal cables from the old drive.
3 Detach the old 3.5-inch drive with the drive frame from the
housing by removing the two chassis screws. Keep the screws for
later use.
4 Remove the four frame screws that hold the old drive to the drive
frame then pull out the drive.
5 Install a new 3.5-inch drive to the drive frame and secure it with
the four frame screws you have previously removed.
AA G500.book Page 44 Thursday, September 13, 2001 6:56 PM