Acer Altos G500 - Manual (Page 98)

4 BIOS Setup utility 88
Hidden
Partition If you want the hidden partition to
become accessible, set this parameter to
Enabled. When enabled, the server boots
to the hidden partition. Disabled
Enabled
Communication
Protocol This parameter specifies the parity, stop
bits, and data length for the COM port to
use for the RDM connection. This is fixed
at N(none), 8, 1 setting and is non-
configurable. N
8
1
COM Port Baud
Rate This parameter lets you set the transfer
rate of the COM for the RDM connection.
The parameter setting depends on your
modem specification; therefore, before
you change the setting of this parameter,
check the documentation that came with
your modem. 9600
57600
Remote
Console Phone
No. This parameter allows you to set the phone
number of the RDM manager station that
the RDM module must dial once RDM is
activated and the Remote Console is
enabled. To set, simply highlight the
parameter and enter the Remote Console
phone number.
If the remote console phone number is
using an (X) line, then you must enter six
commas (,) after the phone number and
before the extension number, if any.
When entering the extension number, we
recommend that you insert a comma after
each number. The commas specify delay.
If this parameter is left blank, the Remote
Console calling function is disregarded.
User input
Dial Out Retry
Times This parameter lets you specify the
maximum number of times the RDM server
must retry to connect to the RDM manager
station once the server fails and RDM is
activated. If the server has completed the
specified number of tries and the
connection still fails, the server bypasses
RDM and goes into normal mode. 2
4
8
Infinite
Parameter Description Option
AA G500.book Page 88 Thursday, September 13, 2001 6:56 PM