Canon REALIS SX80 MARK II - Manual (Page 22)

22
CHAPTER 3 • Appendix
Cppendix CCCCTCC 3
Troubleshooting 31C
Error Message Displayed ■
Error Message Solution
Failed to run application.
Error code 11XX
Or
Failed to run application.
Error code 12XX Restart this software. •
If an error message continues to appear after •
restarting, uninstall this software then reinstall it.
Error occurred while searching for
projector. Projector discovery error 1301
Or
Error occurred while updating projector
information. Projector update error [1301]. Make sure that the administrative computer and •
network is connected using a LAN cable.
The network settings of the administrative computer
•
are not configured correctly. Configure the network
settings so that it can communicate with the
projector.
Cannot Find Projector ■
Cause Solution
Projector is not connected to the network Make sure that the projector and network is •
connected using a LAN cable.
Network settings for the projector are not
configured correctly Make sure that the projector's [Network Function] is •
turned "On".
Confirm the IP address and/or network settings.
•
SNMP settings of the projector is not
configured Configure the SNMP settings of the projector if the •
projector is SNMP-compatible. See the instruction
manual that came with the projector for SNMP
configuration procedures.
COP
Y