Canon REALIS SX80 MARK II - Manual (Page 6)

6
CHAPTER 1 • Introduction
To configure a broadcast address, select the [Broadcast] tab and click the [New]
3
button.
[Specify broadcast discovery settings] dialog will display.
Note
As default, broadcast settings configured on the network card of the -
administrative computer will display in the discovery range list.
Complete the dialog with necessary information and click the [OK] button.
4
Category Description
Broadcast address Enter a broadcast address of the network to discover in "XXX.
XXX.XXX.XXX" form.
Community Name Enter a community name within 15 one-byte alphanumeric
characters and symbols.
Timeout Enter a number of seconds to time out, from 1 to 9.
Password
(SNMP V3 only) Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
Enable encryption
(SNMP V3 only) Place a checkmark if encrypted. Remove a checkmark if not.
To specify an IP address range, select the [IP address ranges] tab and click
5
the [New] button.
[Specify IP address range] dialog will display.
COP
Y