Canon REALIS SX80 MARK II - Manual (Page 3)

3
CHAPTER 1 • Introduction
Introduction CCCCTCC C
Introduction Crocess C1C
Prepare for introduction of this software as shown below.
C Creparing an administrative
computer
Prepare an administrative computer that is
connected to a network. Projectors connected to
the local area network can be managed.
If the network is managed under a subnet,
network settings on the administrative computer
must be configured to gain access to the target
projector. Contact the system administrator for
details.
▼
2 Creparing the Crojector
Connect a projector for management to the
network, and configure its network settings. In
addition, you must configure the SNMP settings
of the projector when using SNMP protocol. For
procedures on configuring the projector, see the
instruction manual that came with the projector.
▼
3 Installing the Software
Install this software on to the administrative
computer.
(see p. 4, 1.3 Installing the Software)
▼
4 Configuring Network
Settings of the Software
Configure the protocol settings and the polling
interval settings for discovery.
(see p. 5, 1.4 Configuring the Network Settings
of the Software)
COP
Y