Canon PIXMA iP100 - Manual (Page 18)

14 Before Using the Printer
2
Prepare to load paper.
(1) Open the Rear Tray Cover.
The Paper Output Slot Cover will open
automatically.
(2) Pull out the Paper Support completely until the
mark and the mark are aligned.
(3) Adjust the position of the Paper Thickness
Lever.
The Paper Thickness Lever switches the
clearance between the Print Head and the
loaded paper to match the media type.
Set it to the left when printing on envelopes or
T-shirt transfers, and right when printing on any
other type of the paper.
3
Load the paper.
(1) Slide the Paper Guide to the left side of the
Rear Tray.
(2) Load the paper in the Rear Tray with the print
side facing UP.
(3) Align the paper stack against the guide on the
right side of the Rear Tray.
(4) Slide the Paper Guide against the left side of
the paper stack.
Do not slide the Paper Guide too strong. Paper
may not be fed properly.
4
Specify the page size and media type settings
according to the loaded paper.
Note
If the corners or edges of the paper are smudged, try to print with the Paper Thickness Lever
set to the left. It may improve print quality.
Reset the Paper Thickness Lever to the right when you finish printing.
Note
Select the size and type of the loaded paper in Page Size (or Paper Size) and Media Type in the
printer driver.
For details on printer driver settings, see “Printing with Windows” on page 18 or “Printing with
Macintosh” on page 19.
(1)
(2)
(3)
(A)
(2)
(3)
(4)
* Do not load higher than the
projection (A).