Canon imagePROGRAF iPF610 - Manual (Page 703)

HP-GL/2 problems
HP-GL/2 problems
Lines or images are missing in the HP-GL/2 data that
was printed.
Cause Corrective Action
The memory is full. Check the size of the data in the print job.
A GL/2 command not supported by this printer was
received. Check the print job and settings.
With HP-GL/2, printing is misaligned.
Cause Corrective Action
The plotter origin is incorrect. Check the printing commands.
Lines Are Printed Too Thick or Thin During HP-GL/2
Printing
Cause Corrective Action
The Line Width setting in the main menu is incorrect. Conrm the selection in Line Width. If ne lines are
printed faint, setting ThickenFineLines to On in the
main menu will print the lines more distinctly. (→P.50)
HP-GL/2 jobs are printed in monochrome (or color).
Cause Corrective Action
The color mode is incorrect. On the printer Control Panel, check the color mode
setting. (→P.50)
For optimal printhead performance, the printer consumes trace amounts of color ink even in monochrome
mode.
HP-GL/2 printing takes a long time.
Cause Corrective Action
Large print jobs with a lot of data take longer to print. On the printer Control Panel, set Input Resolution
to 300dpi. (→P.50)
The printer stops when printing a HP-GL/2 job (the
carriage stops moving)
Cause Corrective Action
The printer is analyzing the print job. Either wait a while for printing to resume, or on
the printer Control Panel, set Input Resolution to
300dpi. (→P.50)
Troubleshooting 689