Night Guard Home Surveillance System C3-RS-665 - Manual (Page 18)

18
VACUUM OPERATED CENTROL LOCKING
Green Wire
Blue Wire
+12V
X Cut
Compressor
Door Switch
30
86
87a
85
87
30
86
87a
85
87
3 Pin
Plug To
Alarm
VACUUM OPERATED DOOR LOCKING
SYSTEM:
TYPICAL OF MERCEDES BENZ
AND AUDI.
Locate the wire under the driver's kick panel. Use
the voltmeter connected to ground and verify that
you have the correct wire. With the
doors unlocked, the voltmeter will receive "12
volts". Lock the doors
and the voltmeter will read "0 volt". Move the
alligator clip to +12V and
the voltmeter will receive "12 volts ".
Cut this wire and make connections. Be sure to
program door lock timer to
3.5 seconds.
(See Alarm Feature B – 3 Programming.)
H9. RS232 C I 3 SERIAL TWO-WAY DATA PORT CONNECTION:
This connector is to be used for Serial Data communications with
idatalink modules by Auto Page only! DO NOT CONNECT THIS TO
ANY OTHER WIRING!
This connector will transmit digital codes to operate all functions of Autopage data
modules. When these modules are used, no other data bus connections need to
be made to the RS-665
. The Data Bus module will receive its commands directly
from the CPU of the RS-665 . This will provide greater theft protection as well as
aid in the installation of this product. The RS-232 serial harness is provided with
all Autopage serial data modules and is not included with the RS-665
. This
two-way data port has been designed for use with all C I 3 compatible
components. C I 3 Telematics system is available at any authorized Autopage
dealer.
This port will only operate correctly with Autopage C
I 3 idatalink Modules .
PROGRAMMING:
Note: This system can keep up to 4 remote transmitters in its memory. If
more than 4 transmitters programmed, the system will keep only the last
4 transmitters.
PROGRAMMING THE REMOTE TRANSMITTER
Enter:
1. Turn the Ignition switch ‘OFF/ON’ 3 TIMES and staying in the ‘ON’
position.