Night Guard Home Surveillance System C3-RS-665 - Manual (Page 25)

25
VOLTAGE CHECKING TYPE:
Enter Start Feature ‘D’ Programming Mode:
1. Turn the Ignition ‘switch ‘ON/OFF’ 3 TIMES and stay in OFF
position.
2. Push the Valet switch 9 times (holding in on the 9th push) until four
chirps with a long chirp is heard then release the valet switch. You are
now in the Start feature ‘D’ programming mode.
Select “Checking Type”:
3. Press the transmitter
+ button to set the “Voltage Checking
Type”. [2] LED flash, [2] horn chirp to confirm this setting
Once you complete step 3, you can adjust and test “Start Timer” as below:
VOLTAGE START PROGRAMMING: (TEST & ADJUST)
While the system is in Start Feature “D” programming mode,
1. Press the
button on the transmitter to start the vehicle.
2. If everything goes well: Wait 10 seconds:
a. If the engine is still running.
I. Press the button on the transmitter to stop engine.
You have completed this programming successfully.
II. Press
button on the transmitter to exit the program mode.
There will be 3 long chirps & 3 parking light flashes for confirmation.
b. If the engine shuts down after the vehicle has started:
I. Press the ‘ button on the transmitter to stop the engine.
II. Press button on the transmitter to set “Check Level” to LOW
position. [1] LED flash, [1] Siren chirp to confirm this setting
III. Repeat the steps 1 – 2 if necessary.
3. If the crank time is too long, (Engine running but starter still cranks):
a. Press the button on the transmitter to stop the engine.
b. Press button on the transmitter to set proper “Start Timer”. The
chirp & LED pause will confirm this entry. (Decrease “Start Timer” is
necessary.)
4. If the crank time is too short,(The engine is not running and the starter
has stopped cranking):
a. Press button on the transmitter to set proper “Start Timer
”.
The
chirp & LED pause will confirm this entry. (Increase “Start Timer” is
necessary.)