Night Guard Home Surveillance System C3-RS-665 - Manual (Page 31)

31
H. Connect terminal 85 of the relay to the Drivers Door side of the pin
switch wire previously cut in step B.
Note: A second 4003 series diode may be required to maintain the
integrity of the hood open, shut down circuit. If this is the case, it
must be installed as shown in the diagram above. The anode (Non
Striped) side must be connected to the WHITE/ BLACK wire (H7/11)
of the Remote Start Unit. The cathode (Striped) side must be
connected to the hood pin switch.
METHOD 2
Ignition Key In Sensor
Switch Closes with Key
In Ignition Cylinder
Connected to ( - ) Negative
Safety Input Wire
White/ Black ( H7/11 )
To Hood Pin Switch
Safety Shut Down ( H8/9 )
1N4003
To connect to the key in sensor circuit as shown for method 2:
A. Locate the control wire that connects the drivers door pin switch to
the key in sensor switch.
B. Cut this wire and connect the ignition cylinder side to chassis ground.
C. Locate the key in sensor switch wire that connects the chime module
to the ignition cylinder.
D. Cut this wire and connect the ignition cylinder side to the Remote
Start Negative Safety Shut down wire WHITE/ BLACK (H7/11), using
a 4003 series diode as shown above.
Note: A second 4003 series diode may be required to maintain the
integrity of the hood open, shut down circuit. If this is the case, it
must be installed as shown in the diagram above. The anode (Non
Striped) side must be connected to the WHITE/ BLACK wire (H7/11)
of the Remote Start Unit. The cathode (Striped) side must be
connected to the hood pin switch.
AFTER THE CONNECTION OF THE NEUTRAL START SAFETY WIRE
AS INDICATED IN ANY OF THE PREVIOUS ALTERNATE
CONFIGURATIONS, THIS CIRCUIT MUST BE TESTED FOR
OPERATION.
Retest by following the steps outlined in the NEUTRAL START SAFETY
TEST shown in this manual.
TECH LINE
Autopage technical assistant is available to Authorized
Dealers ONLY. The (800) tech-line is open from M-S
8:00 am to 5:00 pm pacific standard time.