Electrolux EI30EW45KB - Manual (Page 23)

23
A self-cleaning oven cleans itself with high
temperatures (well above cooking temperatures)
which eliminate soil completely or reduce it to a
fine powdered ash you can whisk away with damp
cloth. If you are planning to use the oven directly
after a self-clean cycle remember to allow time for
the oven to cool down and the oven door to unlock.
This normally takes about one hour.
1. Remove the oven racks and the racks
supports.
2. Be sure the clock is set with the correct time of
day and the oven door is closed.
3. Select oven by pressing either UPPER OVEN
or LOWER OVEN.
4. Press lITE ClEAN for a 2 hours self-clean,
MED ClEAN for 3 hours, or press HEAVy
ClEAN for 4 hours cleaning cycle.
5. Press START. The “DOOR ” icon will flash.
6. As soon as the control is set, the motor driven
oven door lock will begin to close automatically.
Once the door has been locked the “ DOOR ”
indicator light will stop flashing and remain on.
Note: Allow about 15 seconds for the oven door
lock to close.
When the Self-Clean Cycle is Completed
1. The time of day and “ DOOR ” will remain ON.
2. The display will show an “ Hot” message while
the oven is still too hot to open door.
3. Once the oven has cooled down for 1 HOUR,
and the “ DOOR ” icon is no longer displayed,
the oven door can then be opened.
Stopping or Interrupting a Self-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-
cleaning cycle due to excessive smoke:
1. Press
CANCEl.
2. Once the oven has cooled down for
approximately 1 HOUR and the “ DOOR ”
icon is no longer displayed, the oven door can
then be opened.
1. Remove the oven racks and the racks
supports.
2. Be sure the clock is set with the correct time of
day and the oven door is closed.
3. Select oven by pressing either UPPER OVEN
or LOWER OVEN.
4. Press lITE ClEAN for a 2 hours self-clean,
MED ClEAN for 3 hours, or press HEAVy
ClEAN for 4 hours cleaning cycle.
5. Press START. The “DOOR ” icon will flash.
6. As soon as the control is set, the motor driven
oven door lock will begin to close automatically.
Once the door has been locked the “ DOOR ”
indicator light will stop flashing and remain on.
7. Press END TIME.
8. Enter time of day needed for the end of the
cycle (example for “6:00”; 6 0 0).
9. Press START.
Note: Allow about 15 seconds for the oven door
lock to close.
When the Self-Clean Cycle is Completed
1. The time of day and “ DOOR ” will remain
ON.
2. The display will show an “ Hot” message while
the oven is still too hot to open door.
3. Once the oven has cooled down for 1 HOUR,
and the “ DOOR ” icon is no longer displayed,
the oven door can then be opened.
Stopping or Interrupting a Self-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-
cleaning cycle due to excessive smoke:
1. Press
CANCEl.
2. Once the oven has cooled down for
approximately 1 HOUR and the “ DOOR ”
icon is no longer displayed, the oven door can
then be opened.
Setting Self-Clean Cycle
Setting self-clean Setting delayed self-clean
During the self-cleaning cycle, the outside of
the oven can become very hot to the touch. DO
NOT leave small children unattended near the
appliance.
DO NOT force the oven door open. This can damage
the automatic door locking system. Use care when
opening the oven door after the self-cleaning cycle.
Stand to the side of the oven when opening the door
to allow hot air or steam to escape. The oven may
still be VERY HOT.