Aiphone JK-DVF-XP - Manual (Page 4)

PROGRAMMING:
See programming instructions included with the required XP-KIT Programming Starter Kit (sold separately).
Note: Do not attempt to program or use the JK-DVF-XP door station without first reading the
initialization instructions included with the XP-KIT Programming Starter Kit!
CARD READER:
Power Source: 12V DC
Current Requirements: 40mA (Avg)
Terminations: Color-coded pre-wired pigtail
Operating Temperature: -10°~60°C / 14°~140°F
Operating Humidity: 0-95% relative humidity
non-condensing
SPECIFICATIONS:
DOOR STATION:
Power Source: JK-1MED / JK-1MD master
Camera unit: CMOS Camera
Scanning line: 525 lines
Min. illumination: 5 Lux at 1' or less
Terminations: Screw terminals
Operating Temperature: -10°~60°C / 14°~140°F
Wiring Distance: 330ft w/ 87180250C wire
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
FAX (425) 455-0071
Pg. 4
JK-DVF-XP Instr.
0110JD
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
For proper regulatory compliance, the drain wire should be disconnected at the
power supply end of the cable.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The Reader is intended to be powered from a limited power source output of a
previously certified power supply.
TOLL FREE TECHNICAL SUPPORT:
(800) 692-0200
E-MAIL: [email protected]
SPECIFICATIONS
DIMENSIONS:
JK-DVF-XP