Aiphone MK-1MD/A User Manual

Mk-1md, Mk-1md/a, Alphone

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

83659100

05971

® AlPHONE

MK Series

DOOR SENTRY

VIDEO ENTRY SECURITY INTERCOM

Models:

MK-1MD

M ain audio/m onitor station

MK-1MD/A

INSTALLATION & OPERATION MANUAL

Before actually installing MK-1MD(/A), the contents of this Manual
must be thoroughly read and understood.

A

PRECAUTIONS ON INSTALLATION & WIRING

/iy: WARNING

A : CAUTION

(Negligence could result in injury to people or

(Negligence could result in death or serious
injury to people)

damage to property)

A,: GENERAL PRECAUTIONS

Prohibitions to dismantle the unit.

General prohibitions.

Q: Take the unit to earth ground

(§): Prohibitions to subject the unit to water.

A

WARNING

1. Do not change or modify MK-1 MD(/A) equipment. ^

2. Do not connect any power source other than specified to

terminals +, - on MK-1 MD(/A).

Doing so can cause fire or damage the unit. ^

3. The MK-1 MD(/A) equipment must not be exposed to water

or any other liquid, rg)

4. Do not open MK-1MD(/A) monitor unit. The high voltage is

inside.

5. Make sure wires are connected properly before plugging in

the power supply. ^

6 Keep AC outlet away from moisture and dust.

7. Do not put any forcible strength on the monitor of MK-

1 MD(/A). It can cause injury.

A

CAUTION

1. Do not install or make any wire terminations while power

supply is turned on. It can cause electrical shock or
damage the unit.

2. Mount the MK-1 MD(/A) monitor on wall in a convenient

location, but not where it could be bumped or jarred.

3. Do not install MK-1 MD(/A) components in any of the

following locations, as it may cause the system to
malfunction;

-

High or extreme cold temperature area: under direct

sunlight, near equipment that varies in temperature,
in front of air-conditioner, inside a refrigerated area,
etc.

-

Places subject to moisture or humidity extremes.

-

Places subject to environmental conditions, such as

oil, dust, chemicals, salt, etc.

-

Places subject to constant vibration or impact.

A

GENERAL PRECAUTIONS

1. MK-1 MD(/A) equipment, except for MK-DS(/A), is

designed for indoor use only. Do not install outdoors.

2. MK-1 MD(/A) system is not operable during a power

failure.

3. In areas where broadcasting station antennas are close

by, intercom system may be affected by radio frequency
interference.

4. Keep all DC wiring at least 30cm, 20” away from

AC 100 ~ 240V wiring, fluorescent lighting, or dimmer
switches. Otherwise, cross AC wiring at a 90° angle.

Advertising