APC DC Power Plant MX28B-1200 - Manual (Page 49)

Revision B MX28B-1200 PRODUCT MANUAL
MX28B-1200/2400 43
(Table 6-1. Parameter Locations, Descriptions, and Default Values)
PARAMETER DESCRIPTION DISPLAY SCREENS /
DEFAULT SETTINGS
Battery Alarms
Discharge Alarm {1}
[BATT/SET-ALM]
An alarm that is generated if the battery discharge current
exceeds the programmed battery discharge threshold. Batt Disc Alm m+
Minor
High Voltage Alarm {1}
[BATT/SET-ALM]
An alarm that is generated if the magnitude of the battery
voltage rises above the high voltage threshold. Batt HV Alm m+
Minor
Low Voltage Alarm {1}
[BATT/SET-ALM]
An alarm that is generated if the magnitude of the battery
voltage drops below the low voltage threshold. Batt LV Alm m+
Minor
High Temperature Alarm {1}
[BATT/SET-ALM]
An alarm that is generated if the battery temperature exceeds
the high temperature threshold. Batt HT Alm m+
Minor
Low Temperature Alarm {1}
[BATT/SET-ALM]
An alarm that is generated if the battery temperature drops
below the low temperature threshold. Batt LT Alm m+
Minor
RECTIFIER SETUP
Fail Safe Voltage {1}
[MODULES/RECT/PARAM]
Rectifier default output voltage if communication with the
control unit fails. Rect Fail Safem+
-54.00 V
Communications Timeout {1}
[MODULES/RECT/PARAM]
The maximum rectifier communications response time
allowed before a communications failure is declared.
Rect Fail Commm+
1 min
Rectifier Information NOTE: This information can be viewed for each rectifier
installed by using the horizontal arrow keys.
Rectifier Description
[MODULES/RECT/INFO]
Displays the model number of the installed rectifier.
Rect 1 Desc #
MRF28H54
Rectifier Current
[MODULES/RECT/INFO]
A display of the dc output current for the individual rectifier.
Rect 1 Curr #
24.9 A
Current Limit Alarm
[MODULES/RECT/INFO]
The status will be “ON” if the rectifier has been forced into
its current limited mode.
Rect 1 CL #
OFF
Standby Alarm
[MODULES/RECT/INFO]
The status will be “ON” if the control unit is holding the
rectifier in the standby mode. Rect 1 Stdby #
OFF
Fan Fail Alarm
[MODULES/RECT/INFO]
The status will be “ON” if the rectifier fan has failed. Rect 1 FF #
OFF
Rectifier Fault Alarm (RFA)
[MODULES/RECT/INFO]
The status will be on if the rectifier output has failed. Rect 1 RFA #
OFF
Rectifier Alarms
Current Limit Alarm {1}
[MODULES/RECT/SET-ALM]
This alarm indicates that a rectifier has been forced into the
current limited mode. Rect CL Alm m+
n of N