Self clean, For both the upper & lower oven) – LG LDE3017SW User Manual

Page 40

Advertising
background image

40

SELF CLEAN

(For both the Upper & Lower oven)

(cont')

O P E R AT I N G I N S T RU C T I O N S

If it becomes necessary to stop or interrupt a

selfcleaning cycle due to excessive smoke or fire in

the oven:

Touch UPPER & LOWER CLEAR

OFF.

After the oven has cooled down,

the DOOR LOCK will

automatically release allowing you

to open the oven door.

NOTE:
When using the Self Clean feature:

Self Clean can only be run in one oven at a time.
• A Self Clean cycle cannot be started if Oven Lockout

feature is active.

• Once the SELF CLEAN is set, the oven door will

lock automatically. You will not be able to open the

oven door until the oven is cooled. The lock will

release automatically.

• Once the door has been locked the LOCKED

indicator light will stop flashing and remain on.

Allow about 15 seconds for the oven door lock to

close.

• If your clock is set for normal 12 hours display mode

the Delayed Self Clean can never be set to start

more than 12 hours in advance.To set for a delayed

Self Clean cycle 12- 24 hours in advance, see page

18 for instructions to set the control for the 24 hours

time of day display mode.

When the self clean cycle is done

• It will not be possible to open the oven door until

oven temperature has cooled.

• It is recommend to use 3 hours cycle for average

soil, and 5 hours cycle for heavy soil.

• Additional time is needed to cool the oven down.

Therefore, the oven door will not release from the

lock position until after it has cooled.

After the Self Clean cycle

• You may notice some white ash in the oven. Wipe it

off with a damp cloth or a soap-filled steel wool pad

after the oven cools.

If the oven is not clean after one clean cycle, repeat

the cycle.

• If oven racks were left in the oven and do not slide

smoothly after a clean cycle, wipe racks and rack

supports with a small amount of vegetable oil to

make them glide easier.

• Fine lines may appear in the porcelain because it

went through heating and cooling. This is normal

and will not affect performance.

or

Advertising
This manual is related to the following products: