Approach Tech DVR-3024M - Manual (Page 60)

58
1.
Make sure that the key
is unlocked.
2.
Pull the active-handle
outward to detach the
carrier body from the
mobile rack.
3.
Slide the top cover
backward and remove.
4.
Setting the jumper of
your hard disk driver.
The way to set the
jumper of the drive
varies between
manufacturers; please
refer to the instructions
on the driver to set the
jumpers in the master
position.
5.
Attach the interface
connector and the
power connector to the
drive. Please note the
red lining of the IDE
cable and the red wire
of power cable must
line up side by side.
6.
Place the HDD inside
mobile rack. Use four of
the provided screws.
7.
Place the top cover
back to the carrier
body by sliding
forward to secure.
8.
Slide the carrier body
back in the mobile rack.
9.
Push the carrier body
further into the mobile
rack until fully inserted.
10.
Push the active-handle
inward.
11.
Lock the Key.