Approach Tech DVR-3024M - Manual (Page 61)

59
6.3 O.S.D Message
No. O.S.D Message Meanings
1 NO DISK No hard-disk detected after power activated
2 BATTERY LOW
Suggest change the battery and reset the system
time
3 LOADING System Boot up
4 VIDEO LOSS Video loss
5 VIDEO IN Video input source
6 KEY LOCKED Key lock function is on
7 KEY UNLOCKED Key lock function is off
8 n1 OF n2 ITEMS PROGRESS n3 % BACKUP n1/n2 NOW
9 BACKUP COMPLETE Backup complete
10 HD2 SPACE NOT ENOUGH HD2 has not enough space for backup
11 NO ENTRY FOR BACKUP No backup is possible.
12 BACKUP INCOMPLETE
Backup incomplete, since the user has pressed
the STOP button to stop it
13 NOT FOUND
The system cannot find a video in the Search
function.
14 END
Playback of recorded video has reached the end
point
15 DISK FULL
Hard-disks are full; this happens only when the
DISK FULL item in the setup menu is set to
STOP.
16 EMPTY
The user presses the PLAY button or uses the
SEARCH function, but no video can be played.
17 SET TO NTSC, PLS RESTART
System has to be set to NTSC, please reboot
(PAL is similar)
18 SOFTWARE UPDATE Software update
19 PLEASE RESTART
The system should be rebooted after the software
has been updated
20 NO DISK
The user has pressed the Save key without
putting in an SD card, or there is a disk error.
21 DATA NOT CONTINUOUS
The system finds data in installed HDs cannot be
used contiguously. Suggest you remove HD2
from the system.
22 DISK ATTACHED HD2 has been attached.
23 DISK REMOVED HD2 has been removed.
24 FAN STOPPED The chassis fan has stopped for over 30 seconds.
25 HDn ERROR AT xxxxx
There has been a hard-disk error during
recording, where n is the hard-disk number and
xxxxx is the hexadecimal location.
26 NOT PRESENT
When the user tries to clear a disk that was not
attached in the setup menu.
27 SAVE TO DISK Start saving to the JPEG file.
28 SAVE TO Fnnn. JPG Save to Fnnn. JPG (where nnn= 0..999)
29 SAVE OK Saving to the JEPG is ok.
30 SD CARD WRITE PROTECTION An SD card is write-protected; or, there is an error