LG DU-27FB34C - Manual (Page 50)

Page 50
Installer Menu
76-I. DEFEAT XDS
Set to 1 to disable XDS display. Set to 0 to enable
XDS display. XDS data (provided at the discretion
of the broadcaster), is available only on analog
channels. After a channel change, wait 5 seconds
then press ENTER to see XDS data, if available.
77-I. NOT USED
78-I. UPN MSB
User programmable number, most significant byte
readable by M.P.I. command.
79-I. UPN MSB-1
User programmable number, most significant
byte-1 readable by M.P.I. Command.
80-I. UPN MSB-2
User programmable number, most significant
byte-2 readable by M.P.I. command.
81-I. UPN LSB
User programmable number, least significant
byte readable by M.P.I. command.
82-I. CHKSM ERROR
Enforces rigid M.P.I checksum validation.
Set to 1 for validation.
Set to 0 to turn off.
83-I. HANDSHK TIME
Adds an additional delay to the handshake time
which is 64 msec, thus relaxing M.P.I. timing
requirements to be compatible with PC based
Windows controlled systems, range is 0 - 5.
Set to 0 to retain standard 64 msec delay.
Set to 1 - 5 to increase @ 16 msec ea., the delay
up to 144 msec.
84-I. PERMANENT BLK
Allows Parental Control blocking schemes to be
permanent by removing the blocking hours func-
tion. Set to 1 to install Parental Control blocking
restrictions permanently. Set to 0 for user-specified
hours control of blocking schemes.
85-I. A MUTE TIME
Controls audio muting delay time when switching
between AUX sources. Range is 0 to 254 msec.
86-I. V MUTE TIME
Controls video muting delay time when switching
between AUX sources. Range is 0 to 254 msec.
87-I. NOT USED
88-I. EN NOISE MUTE
When set to 1, the audio signal volume is limited
to a minimum value while receiving no signal from
the broadcaster.
89-I. POKE ENABLE
When set to 1, writing to Non-volatile Memory thru
M.P.I. Is enabled.
90-I. KEY LOCK
When set to 1, front keyboard functionality is dis-
abled. When set to 0, keyboard is enabled.
91-I. NOT USED
92-I. NOT USED
93-I. NOT USED
94-I. NOT USED
95-I. AUDIO MD DISP
When set to 1, Audio Mode Information is enabled
to appear as part of the Channel-Time Display.
96-I. NOT USED
97-I. NOT USED
98-I. NOT USED.
99-I. NOT USED.
100-I. NOT USED.
101-I. NOT USED.
Detailed Descriptions for Installer Menu Items 76-I through 101-I