Language, English français español, Installation test (exhaust check) – LG DLGX8501V User Manual

Page 30

Advertising
background image

30

INSTALLATION INSTRUCTIONS

Installation test (Exhaust check)

Once you have completed the installation of the dryer, use this

test to make sure the condition of the exhaust system is adequate

for proper operation of the dryer. This test should be performed

to alert you to any serious problems in the exhaust system of your

home.

• Your dryer features FLOW SENSE

TM

, an innovative sensing system

that automatically detects blockages and restrictions in dryer

ductwork. Keeping ductwork clean of lint buildup and free of

restrictions allows clothes to dry faster and reduces energy use.

To activate the Installation test:

1. Remove the drying rack and literature, and then close the

door.

Do not load anything in the drum for this test, as it may

affectthe accuracy of the results.

2. Press and hold the SIGNAL and TEMP. CONTROL buttons

and then press the POWER button.

This button sequence activates the installation test. The code

“Flow check” will display if the activation is successful.

Language

English

Français

Español

Language

English

Français

Español

Language

English

Français

Español

3. Press START/PAUSE button.

The dryer will start the test, which will last about two minutes.

The heater will be turned on and the temperatures in the

drum will be measured.


4. Check the display for results.

During the two minutes test cycle, monitor the FLOW SENSE

TM

display on the control panel. If no bars are displayed, when

the cycle ends, the exhaust system is adequate. If the exhaust

system is severely restricted, the display will show four bars.

Other problems may also be shown with error codes. Refer to

the next page for error code details and solutions.

5. END of Cycle.

At the end of the test cycle, “End Of Cycle” will display. The test

cycle will end and the dryer will shut off automatically after a

short delay.

Language

English

Français

Español

NOTE

The dryer should be cool before starting this test. If the dryer

was warmed up during installation, run the AIR DRY cycle for a

few minutes to reduce the interior temperature.

NO BARS: OK

FOUR BARS: RESTRICTED

MFL67731015_en_140128.indd 30

2014.1.28 4:18:51 PM

Advertising