LG LRV790R - Manual (Page 36)

34
CLEANING THE SIDE BRUSH
Foreign objects/materials such as hair can easily adhere to the side
brush. Remove such materials at least once a week.
If excessive amounts of foreign materials are stuck to the brush,
there is the risk of damage to the brushes.
If the floor is rough or walls are frequently cleaned, the side brush may bend or become damaged. In this
case, use the following method to straighten the side brush.
1. The following procedure is helpful in restoring
deformed brushes.
2. Turn off the power by switching the main switch
off on the rear off the unit.
3. Place the Hom Bot at the end of a table to make
cleaning the side brush easier. Make sure that the
Hom Bot is not in danger of falling.
4. Soak the side brush in warm water.
5. Press down on the side brush for about ten
seconds so that it is completely submerged in
the water.
6. Slowly wipe the side brush by sliding it through
your hand.
7. Rotate the side brush and repeat steps 4­6 for
each section of the brush.
8. Use the side brush only after it has completely
dried.
1. Remove the screws by using a driver and separate
the Side Brush from the main unit.
2. Remove any hair after the separation.
3. Assemble the Side Brush by replacing it onto
the bottom of the Hom Bot, with the 'R' and 'L'
marking of the Brush matching the counterparts
on Hom Bot.
Side Brush management