LG H20J54DT - Manual (Page 51)

Page 51 206-4065
LT2000/LT2002 QuickSet Clone Programmer
Use the QuickSet II “Clone” Programmer
to copy the setup from a “master” TV
then quickly transfer the setup to dupli-
cate TV's; must be the same model num-
ber as the master TV.
QuickSet II Programmer
LT2000
®
ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS, USA
• heartbeat power on communications ok
• slow power on
no communications
• green battery ok
• red battery low
Blink pattern
Color Reset
Status Indicator
Connect cable to
TV MPI Jack and
follow on screen
instructions
MPI
LT2000/LT2002
Clone Programmer
RF Coxial Wire
(75 ohm)
Antenna
Learn Master TV Setup
Typical MPI Connections
QuickSet II Programmer
LT2000
®
ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS, USA
• heartbeat power on communications ok
• slow power on
no communications
• green battery ok
• red battery low
Blink pattern
Color Reset
Status Indicator
Connect cable to
TV MPI Jack and
follow on screen
instructions
MPI
M.P.I.
Antenna
Cable
Typical
TV Back
M.P.I.
Digital
Antenna
LT2000/LT2002
Clone Programmer
TV Back Panel
(Expanded View)
RF Coxial Wire
(75 ohm)
Antenna
Teach Other TV the Setup
Typical MPI Connections
M.P.I.
Antenna
Cable
Typical
TV Back
M.P.I.
Digital
Antenna
TV Back Panel
(Expanded View)
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN
The optional QuickSet II Clone Programmer (LT2000/LT2002) allows custom setup
and programming information to be quickly copied from a master TV into multiple
identical television sets. Once learned from the master, setup data is retained in
the clone programmer for future use.
When using the LT2002, cloning operations will work only if the TV is tuned to an
Analog channel with a quality signal and operating with a stable picture dis-
played. To operate the LT2002, use the indicated keys on a HealthView Installer’s
remote or the remote shown on page 16.
Notes: Use only one MPI port for cloning. Do not run Auto Program while cloning.
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.