Hplpcfg command-line examples, Using lo100cfg, Lo100cfg command-line syntax – HP ProLiant DL380 Server User Manual
Page 53
Meaning
Value
There was no adapter or Emulex HBA found on this host.
5
There was an error retrieving the I/O address.
6
The WWID was invalid because of one of the following:
7
•
An invalid value for WWID and BootDeviceWWID, and not a hex value
•
The WWID specified for HBA in the .ini file does not match any HBAs found on the host (for the
/l option only)
The LUN was invalid.
8
Invalid value; for enable/disable value is not 0 or 1 (for /l option only)
0x10
Incorrect iboot BIOS code loaded (for /l option only)
0x11
General error:
0xFF
•
Initialization error (for both /l and /s option)
•
Cannot read HBAs WWPN (for /s option only)
HPLPCFG command-line examples
hplpcfg /s hba.ini generates hba.ini with the following content:
[HBA0]
WWID=11111111
HostAdapterBiosEnable=1
SelectBootEnable=1
BootDeviceWWID=
BootDeviceLUN[0]=
You must edit hba.ini and add the following boot device information:
[HBA0]
WWID=11111111
HostAdapterBiosEnable=1
SelectBootEnable=1
BootDeviceWWID=22222222
BootDeviceLUN[0]=3
You must then invoke the tool to load the contents of hba.ini input to the HBA NVRAM: hplpcfg /l
hba.ini.
Using LO100CFG
LO100CFG enables you to configure the LightsOut 100 device that is available on the HP ProLiant
100 series servers.
Under Windows, WMI is used through the Microsoft_IPMI class, make sure WMI is installed in
the Windows PE environment.
LO100CFG command-line syntax
lo100cfg [ -h | -x | -v | -i "file.xml" | -o "file.xml" | -s ]
Using LO100CFG
53