HP Matrix Operating Environment Software - Manual (Page 80)

storage port WWN and LUN identifier are required before you can activate the logical
server.)
7. Optional: Enter the storage port WWN for each server WWN. (This value must be entered
before the logical server can be activated.)
8. Optional: Enter the LUN identifier for each server WWN. (This value must be entered before
the logical server can be activated.)
9. Repeat steps 1 through 8 for each storage volume for this logical server.
Figure 6-6 Create logical server SAN volume and path definition
Validation status
After you have specified your storage configuration, confirm that the server WWN has been
associated with the storage port WWN and LUN by pressing the Validate button.
See “Validating storage” (page 89) for more information.
Defining a file (VM) storage entry
The File (VM) Storage Entry screen allows you to specify the file storage configuration for an
ESX or Hyper-V virtual machine logical server.
NOTE: A File (VM) Storage Entry cannot be inserted into the storage pool. A logical server can
be associated with only one File (VM) Storage Entry, and the storage entry cannot be shared.
NOTE: If you want to the ability to move the virtual machine logical server to a server with
Virtual Connect, specify SAN storage instead of File (VM) storage. See “Defining a SAN storage
entry” (page 77) .
Perform the following steps to define a File (VM) storage entry.
1. Enter the “File (VM) storage entry definition” (page 81)
2. Enter the “File (VM) storage selection” (page 81)
80 Defining storage for logical servers