Operations, Power up the server, Power down the server – HP ProLiant DL145 G3 Server User Manual
Page 5: Remove the access panel
Operations 5
Operations
Power up the server
To power up the server, press the Power On button.
Power down the server
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On button
does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
IMPORTANT:
If installing a hot-plug device, it is not necessary to power down the server.
1.
Shut down the operating system as directed by the operating system documentation.
2.
Press the Power On button to place the server in standby mode. When the server activates standby
power mode, the system power LED changes from green to off.
3.
Disconnect the power cords.
The system is now without power.
Remove the access panel
1.
Power down the server (on page
2.
Extend and remove the server from the rack.
3.
Remove the access panel:
a.
Loosen the thumbscrew or remove the screw that secures the access panel.
b.
Slide the access panel back about 1.5 cm (0.5 in).
c.
Lift and remove the access panel.
NOTE:
The server may look different from that shown.