Route:control, Default, Syntax – Agilent Technologies Multiple Channel Controller 85330A User Manual
Page 116: Example, Route:delay, Route:control -6 route:delay -6
7-6
85330A Multiple Channel Controller
Remote Programming Command Reference
Standard Command Reference
ROUTe:CONTrol
Controls the TTL state of the rear panel AUX 1 connector.
Default
Default is a TTL LOW.
Syntax
OUT:CONT <data>;
Example
ROUT:CONT 0;
Sets AUX 1 to TTL LOW
ROUT:CONT 1;
Sets AUX 1 to TTL HIGH
NOTE
The state of AUX 1 must be set before entering run-time mode.
ROUTe:DELay
Adds a specific amount of delay between a switch address entry being
asserted and the issuance of a measurement trigger. Delay is entered in
micro-seconds.
Default
The default is 160 micro-seconds.
Syntax
ROUT:DEL <micro-seconds>;
Example
ROUT:DEL 200;
Set the trigger delay (settling time) to 200 micro-seconds.
NOTE
Most solid state switches are capable of changing states within a few
micro-seconds.