AltiGen comm ACM 5.1 - Manual (Page 277)

AltiWare ACM 5.1 Administration Manual 263
C
H A P T E R
20
Paging Group Configuration
The IP paging group is a group of IP phones that can receive station paging. This feature
also can be used as IP zone paging by creating multiple paging groups.
Implementation details:
•
The paging signal uses AltiGen's proprietary H.323-ATPS protocol. You need to have
H.323 tie-trunk channels to be able to implement IP paging.
•
Each paging session requires one G.711 codec channel. The voice stream is multicast
to multiple IP phones on the LAN.
•
Any extension (analog or IP) can initiate a paging call by dialing #46 + the Paging
Group number.
• When paged, an IP phone in idle state will automatically turn on the speaker, play a
beep, and then play the page.
• When receiving an incoming call during a paging session, the IP phone will
automatically stop the paging session and start ringing.
• The IP phone user can terminate a paging session by pressing the Release key on
the phone.
• IP phones in DND mode will not be paged.
To configure paging, select PBX > Paging Group Configuration.