HP StorageWorks XP10000 Disk Array - Manual (Page 102)

Command Line Interface Commands 102
Table 4-78 AddReplication Command Parameters
Parameter Name Status Description
replicationfunction Optional Specify the type of operation that is to be executed with the copy
pair:
BusinessCopy
: Execute Business Copy XP.
ContinuousAccess
: Execute Continuous Access XP.
ContinuousAccessExtension : Execute Continuous
Access XP Extension.
Snapshot
: Execute Snapshot XP.
The default value is as follows:
• When P-VOL and S-VOL are located in the same storage
subsystem: BusinessCopy
• When P-VOL and S-VOL are located in different storage
subsystems: ContinuousAccessExtension
fencelevel
Optional Specify the P-VOL fence level as follows (default = Never).
The fence level is ignored for Business Copy XP, Continuous
Access XP Extension, and Snapshot XP.
Never
: If you specify Never, a host write request to P-VOL will not
be rejected even though the MCU was able to change the status of
a S-VOL pair into the suspend status.
Data
: If you specify Data, a host write request to P-VOL will be
rejected when an update copy fails.
Status
: If you specify Status (StorageWorks XP Disk Array), a
host write request to P-VOL will be rejected only when the MCU
cannot change the status of a S-VOL pair to the suspend status.
copytracksize Optional Specify a copy pace (number of tracks copied at one time during
initial copy), as an integer between 1 and 15.
The default value is 3 for the StorageWorks XP Disk Array.
This parameter cannot be specified when Snapshot XP is being
used.
Table 4-79 GetHost Command Display and AddReplication Command Parameters
Location of Value Displayed by the GetHost
Command Item Name Corresponding Parameter
ReplicationGroup replicationGroupID replicationgroupid
pvolHostID pvolhostid
pvolInstanceNumber
pvolinstancenum
pvolPortNumber pvolportnum
svolHostID svolhostid
svolInstanceNumber
svolinstancenum
svolPortNumber
svolportnum
ReplicationInfo pvolSerialNumber pvolserialnum
pvolArrayType pvolarraytype
pvolDevNum
pvoldevnum
svolArrayType
svolarraytype
svolSerialNumber svolserialnum
svolDevNum svoldevnum
copyTrackSize copytracksize
You can create a copy pair in one of three ways.
The first method is adding a copy pair to an existing copy group that is specified in the RAID Manager
configuration definition file, by using the following command: